1/3HP Outdoor Condenser Fan Motor, 208-230 volt, 1075 RPM, 2.4AMP; Capacitor (not included): 7.5 MFD/370V;
Replaces: AOS Century FSE1036S, Emerson: 1861, MARS 10729, Fasco D908, GE/Genteq 3729, Packard 43729, Rheem Protech W51-13CJA1-01, Carrier RCD: P257-8729, York Source 1: S1-FHM3729;
Repair video: https://youtu.be/VxEcFCR6TkI In addition, the motor comes with drain plugs on both end-shields. If you install the motor shaft (facing) down, you need to remove the drain plug on the shaft side end-shield. If you install your motor shaft up, you need to remove the plug on the non-shaft end. This will allow moisture and condensation to drain out of the motor
All Angle, ball bearing; Rheem mounting holes w/screws installed; Water slinger on shaft; Thru-bolt or band mounting; Double full flatted shaft;Class B insulation; Single phase, 60 hertz; Thermal overload protected; Fan duty, continuous, air over; Totally enclosed non-ventilated; 36 inch leads
Ideal replacement - this air conditioner condenser fan assembly is engineered to match the fit and performance of the stock condenser fan on specific vehicles
Complete package - assembly is designed with the same materials and components as the original part
Quality assured - components are tested in laboratory settings to ensure performance
Cost effective and reliable - trustworthy manufacturing for far less than same part at the dealership
John Carter is the owner and CEO of AcedProducts.co—a popular online website that analyzes tens of thousands of reviews on various products to show you the bestsellers in any category. His goal is to make online shopping much easier than it's ever been by eliminating the need to guess which products are good and which ones are bad.
"Amazon, Amazon Prime, the Amazon logo and Amazon Prime logo are trademarks of Amazon.com, Inc. or its affiliates".
