SINGLE-PHASE CIRCUIT: This single-phase asynchronous motor speed controller can be used for 24V, 36V, 90V DC motors
HUMANIZED SHELL DESIGN: This electric speed regulator has small size, high precision, wide speed controlling range, low power consumption, Used for single （1/3）phase DC motor.
CONVENIENT SPEED CONTROL: The Speed Regulator with adjustable knob can be used to adjust voltage freely, convenient and simple.
LONG SERVICE LIFE: Our Knob motor speed controller with Over Current protection and short circuit protection.(with 5A fuse)
★ Fine quality made with high quality circuit board which ensures a longer service life.and this simple and easy-to-use DC motor speed controller has an stable performance.
★ Product introduction The motor speed controller uses screw terminals for convenient and quick wiring. It is equipped with an instantaneous start/stop switch and a speed control potentiometer.
★ Seller's warm tips 1. The digital display is the percentage non-motor actual speed; 2. The input voltage must be divided into positive and negative, can not input 220V household electricity, the input voltage should be equal to the rated voltage of the motor (6-60V), such as the rated voltage of the motor 12 input 12V motor 36V input 36V motor.
★ Speed Controller Features Comes with a momentary start/stop switch and a speed control potentiometer.
DROK DC motor driver input voltage range is DC 6.5V-27V, can be input DC 12V or 24V, rated output current of each port is 7A, total output power is 160W.
STRONG DRIVE: the motor controller board adopts dual H bridge, can drive two DC motors at the same time.
FORWARD and REVSERSELY ROTATE: the IN1, IN2/IN3, IN4 port can control forward or reverse motor rotation.
PWM SPEED CONTROL: enable signal terminal (ENA) input PWM can regulate speed, PWM frequency range 0-10KHZ.
DROK motor speed controller operating voltage range is DC 7-60V, max drive current is 20A, control power advice 12V within 200W, 24V within 300W, 48V within 350W.(for reference, depending on motor)
Protection & Easy Installation: the dc motor driver is designed with Aluminum shell prevents it from easily damaged; there are holes in its sides and bottom, making it easier to install
Speed Control: the improved version control motor speed from original 1%-100% to stepless speed change
Special Features: our motor control board is FR4 double panel, reasonable circuit management and fuse allows Stable performance and small heating
This Brand New 1803BK DC Motor Speed Controller allows controlling the direction of a DC the motor using a Pulse-Width-Modulated (PWM) DC voltage with a Duty Cycle fully the product adjust from 0%-100%.
With a self-recovery fuse 2A and a Power-On LED light.
This is a speed governor with a maximum current of 2A. If the continuous current is greater than 0.5A, the 775 motor and the stroller motor will not move. Don't buy it wrong. It is not recommended to supply power greater than 12V, such as 12V lead-acid batteries, which may cause damage to the governor
If the current is too large, it will be automatically disconnected, and the fuse will automatically recover after cooling.
John Carter is the owner and CEO of AcedProducts.co—a popular online website that analyzes tens of thousands of reviews on various products to show you the bestsellers in any category. His goal is to make online shopping much easier than it's ever been by eliminating the need to guess which products are good and which ones are bad.
"Amazon, Amazon Prime, the Amazon logo and Amazon Prime logo are trademarks of Amazon.com, Inc. or its affiliates".
